MEP Services

MEP Services

Mechanical and electrical engineers are specialists, commonly referred to as “MEP” (mechanical, electrical, and plumbing) when engaged in the building design fields. Mechanical engineers design and oversee the heating ventilation and air conditioning (HVAC), plumbing, and rain gutter systems. Plumbing designers often include design specifications for simple active fire protection systems, but for more complicated projects, fire protection engineers are often separately retained. Electrical engineers are responsible for the building’s power distribution, telecommunication, fire alarm, signalization, lightning protection and control systems, as well as lighting systems.

OUR SERVICES INCLUDE

Mechanical

  • Mechanical Drafting and Design
  • Mechanical Detailing
  • 3D REVIT
  • Modeling
  • Shop/Fabrication Drawings
  • Product Designing and Development
  • Schematic heating and cooling system design
  • Heating and cooling equipment election
  • Heat loss and/or gain calculations
  • Plant room layout design
  • Fire protection system design
  • Duct layout drawings

Electrical

  • Electrical schematics
  • Electrical, power and lighting plans
  • Electrical site plans
  • Electrical one line diagrams (Riser Diagrams)
  • Electrical panel schedules and
    distribution panels
  • Wiring Diagrams
  • Cable/harness Drawings
  • Power distribution systems
  • Interior lighting
  • Exterior lighting
  • Emergency and exit lighting
  • Fire alarm systems
  • Outlets and raceway systems for voice and data cabling systems
  • Calculation of Lux level
  • Selection of Wire size
  • Selection of MCB rating
  • Calculation of Busbar size
  • Selection of Lighting Fixture
  • Lux Level Lighting Fixture Location
  • Prepare Receptacle plan
  • Lighting fixture schedule
  • Outdoor Lighting plan
  • Panel Schedule with all details required

Plumbing

  • Plumbing and Drainage Drafting Services
  • Design and Drafting services for domestic water plumbing set up
  • Natural and LP gas piping drafting and planning services
  • Compressed air and medical gas system plan drawings
  • Demolition and existing plan drawings
  • Isometrics, Riser diagrams, details, schematics and schedules
  • Shop drawings, As-builts, specifications and coordination
  • Legends and addendums supplement plumbing construction drafts
  • Equipment Schedule
  • Establish plumbing Loads-Load analysis
  • Establish utility stub outs and pipe sizes
  • Locate and coordinate pipe sleeve requirements
  • Determine pipe chase space requirements
  • Specify sanitary fixtures
  • Water supply and distribution plans and details
  • Wastewater collection system
  • Soil report evaluation
  • Layout of below and above grade piping
  • Sewerage plans and details
  • Establish sewer loads
  • Establish main pipe size and co-ordinate stub locations
  • Expansion loops for seismic requirements
  • Vent sizing and routing
  • Roof drain calculation
  • Pump sizing and location

OUR SERVICES

MEP Services

Fire sprinkler design

Title 24 Report & Energy Analysis

LEED Certification

Heating, A/C & Ventilation Design

Electrical design

Facilities system
design

Commissioning Services

Plumbing design

Solar Design

Pin It on Pinterest